Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
• Measure width of opening.
Step 1
• Refer to gures 1A, 1B, 1C, 1D to determine the correct installation.
1A
29.75"-32.5"
(75.5 to 82.5 cm)
• To add an extension, begin by removing both the upper and
Step 2
lower plugs from the side of the gate frame. You may need to
use a athead screwdriver to remove the plugs. Figure 2A.
• Attach both the upper and lower adapters to the extension pole.
• Install the fully assembled extension by inserting the upper and
lower extension adapters into the gate in the holes where you
removed the plugs. Figure 2B.
• Reinsert both plugs, then insert the bolts with rubber pads into
the holes on the outside of the extension. Figure 2C.
2A
IMPORTANT: Do not install two extensions on the same side of the gate.
1B
33"-35"
(83.8 to 88.9 cm)
With 1-Bar Extension
2B
Upper plug
Lower plug
1C
35.4" – 37.8"
(89.9 to 96 cm)
With 2-Bar Extension
1D
37.8" – 40.5"
(96 to 102.87 cm)
With 1-Bar and 2-Bar Extensions
2C
Page 3
Publicidad
