Installation
Instructions
Questions? Visit our Website at: cafeappliances.com
In Canada, visit cafeappliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
Built-in style models (model CYE and CWE) are top
heavy, especially with any doors open. These models
must be secured with the anti-tip floor bracket to
prevent tipping forward, which could result in death or
serious injury. Read and follow the entire installation
instructions for installing the anti-tip floor bracket
packed with your refrigerator.
IMPORTANT
•
—
and ordinances. Save these instructions for local
inspector's use.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
can vary
Water Line Installation
30 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
TOOLS YOU MAY NEED
Adjustable Wrench
1/4 Outer Diameter
Compression Nut
and Ferrule (sleeve)
49-60820-1
Tip Over Hazard.
Observe all governing codes
1/8
Socket Ratchet/Driver
Pencil
1/8 Drill Bit and
Electric or Hand Drill
Pliers
Level
Bottom Freezer
Refrigerator
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorway, the
refrigerator door and freezer drawer can be removed.
• To remove the refrigerator door, see the Installing
the Refrigerator section.
• To remove the freezer drawer, see the Removing
the Freezer Drawer section.
WATER SUPPLY TO THE ICE MAKER AND
DISPENSER
If the refrigerator has an ice maker, it will have to
be connected to a cold water line. A Café water
supply kit (containing tubing, shutoff valve, fittings
and instructions) is available at extra cost from your
dealer, by visiting our website at
cafeappliances.com/parts. In Canads, visit
cafeappliances.ca/parts.
1/4 &
Allen Wrenches
Flat-Head Screwdriver
Phillips-Head Screwdriver
1/4 Nut Driver
Tape Measure
Torx T20, T25
23