Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.3 Switching the laser on / off
Press the on/off button to switch the laser beam on. Press the button again
to switch the laser beam off.
The laser is active for 7 minutes after being switched on. It switches off
automatically when this period of time expires.
6
Care, transport and storage
6.1 Transport
▶ Use the Hilti shipping box or packaging of equivalent quality for trans-
porting or shipping your equipment.
6.2 Cleaning and drying
1. Blow dust off the laser exit window.
2. Do not touch the laser exit window with your fingers.
3. Clean the tool with a soft clean cloth. If necessary, moisten the cloth
slightly with pure alcohol or a little water.
Abrasive cleaning materials may scratch the glass and impair the
accuracy of the laser tool.
4. Observe the temperature limits when drying the equipment.
7
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, contact Hilti Service.
Trouble or fault
Laser does not work. The battery is dead.
8
Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
10
English
Possible cause
The battery is incorrectly
connected.
On/off button or laser
faulty.
Action to be taken
▶ Change the battery.
→ page 9
▶ Check the connection
between battery and
battery clip. Make
sure that polarity is
correct. → page 9
▶ Contact Hilti Service.
2266038
*2266038*
Publicidad
Tabla de contenido
