Allen + Roth 1227VA-48-201-900 Manual Del Usuario página 6

INSTALLATION INSTRUCTIONS
4. Lower the sink brackets (LL) over the bolts
(KK) and allow to rest on the sink lip. Adjust
location of bracket to firmly grasp sink lip.
Lower lock washers (NN) over bolts (KK) and
secure with nuts (MM). Hand tighten nuts (MM)
with included wrench (OO).
DO NOT OVER TIGHTEN!
Tip: Check that the sink placement is well
centered front to back and side to side of the
stone top cut out before allowing the silicone
caulk to dry. If the sink is not centered well
unscrew sink clamps, re-adjust the sink position
and re-tighten the sink brackets.
Hardware Used
Sink bracket
LL
Nut
MM
5. To remove drawers preassembled in vanity (A),
fully extend drawers. Locate plastic levers on
metal glide tracks at left and right sides of
drawer box.
To disengage drawer box from glides, push on
plastic levers. Then, gently lift drawer up to
remove it from vanity (A).
4
LL
x 4 Lock Washer
NN
x 4 Wrench
OO
5
A
6
OO
MM
NN
1
KK
G
D
1
3
2
x 4
x 1
2