Uline H-8447 Manual Del Usuario página 3

1. Place the back (1) on a protected surface.
The bottom flange should be facing upward.
(See Figure 1)
Flange faces upward
NOTE: When bolting the unit together, leave the
bolts slightly loose until Step 7, unless otherwise
specified.
2. Attach the left side (2) to the back by placing flange
around the back, and bolting the back and side
together with seven bolts and nuts. Be sure that the
lances on the shelf adjustment strips point up.
(See Figure 2)
Lances point up.
3. Attach the top (7) to the unit by sliding the outer
flange over the back of the unit and the side flange
on the side panel of the unit. The threaded studs
should go through the holes in the top flange of the
side and fasten with three nuts. Attach the back to
the top using four bolts and nuts. (See Figure 3)
PAGE 3 OF 12
ASSEMBLY
1 Figure 1
2 Figure 2
Flange goes
under back.
Figure 3
7
4. Attach the right side (3) to the back as you did in
step 2. Make sure the flange is around the back and
that the lances on the shelf adjustment strips are
pointed in the same direction as those on the left
side. Push the side panel up so the studs in the top
go through the holes in the top flange of side and
fasten with three nuts. (See Figure 4)
5. Attach the sill (5) to the sides. Place nut loosely on
each of the studs and slide the ends of the sill into
the slots on both sides of the unit. Then, securely
tighten the nuts. (See Figure 5)
5
Slide ends into the slots on
the bottom of the sides
6. Place rear flange of the bottom (6) into the bottom
lances of the sides. The flange with two holes should
face the front, hanging over the sill. Insert bolts
through the bottom and sill with the head facing the
front of the unit. Secure with two nuts.
(See Figure 6)
Insert shelf
into bottom
left and right
side lances.
Figure 4
3
Figure 5
Nuts placed loosely
on studs of the sill.
Figure 6
6
0721 IH-8447