Beurer EM 38 Instrucciones Para El Uso página 24

Note:
If you change the program during
the stimulation (for example from A
to B), the initial intensity in the new
program increases incrementally
up to the previously set intensity.
This can be stopped if necessary
by pressing the
[2] for two seconds or by switching
off the unit by pressing the on/off
button [1] for two seconds.
Stopping impulses that are too strong
You can decrease the intensity at any time
or switch off the unit by pressing the on/off
button [1] (approx. 2 seconds).
Adjusting the intensity
Press the intensity button [2] to increase
the intensity incrementally or press the
intensity button [2] to lower the intensity.
You can adjust the intensity in 20 incre-
ments. Depending on the intensity level,
you feel a prickling at first that can esca-
late to a muscle contraction.
Select a setting that is within your
comfort level.
Preventing unwanted pulse changes
To prevent an accidental increase in inten-
sity during a treatment session, simply
activate the keylock. To do so, press the
program selection button P [3] for approx.
2 seconds. An acoustic signal sounds and
the " " symbol appears in the display
[5].
To cancel the keylock, press and hold
down the P [3] button for approx. 2 sec-
onds.
24
intensity button
Reacting to unpleasant sensations
If you feel a stinging or itching sensation,
switch off the unit and proceed as follows:
• Check whether the electrodes are work-
ing properly or are defective.
• Check whether the round cover is still
present over the electrode connections.
• Take off the belt and moisten it com-
pletely once again.
• When refitting the belt, ensure good
skin contact and good moistening.
Inserting a pause
If you want to take a break or pause a pro-
gram, press the pause button [1] briefly.
An acoustic signal sounds and the "II"
pause symbol flashes in the display [5].
You can resume the program by pressing
the button [1] again.
Contact detection
If the electrodes have no contact with the
body, the intensity is set automatically to
zero. This prevents unwanted stimulation.
The intensity cannot be increased without
contact with the body.
Memory function
The unit stores the most recently config-
ured program.
After a battery change, the unit starts with
the first program again.