BaByliss PRO POWERFX X810B Instrucciones De Operación página 5

ADJUSTABLE TAPER LEVER
The taper lever is positioned at your thumb. You can hold
the clipper in your hand and adjust the lever at the same
time – while you are clipping.
The taper lever adjusts the closeness of the cut from a close cut with the taper lever
in the UP position, to a longer-length cut with the taper lever in the DOWN position.
To increase cutting length, slowly push the lever down. To cut closer, push the lever
up. Because a different cutting edge is used in each setting, using the taper lever
lengthens the life of your blades.
Packed-in hair can slow down any clipper. To remove hair without removing the
blades, keep the clipper on and quickly push the taper lever back and forth from
"close" to "longer" cut several times. If you do this every time, especially after
heavy hair cutting, the blades should remain free of cut hair.
POWER SCREW
The power screw permits you to adjust the power of your clipper. You may find it
necessary to adjust it if the power in your salon is low.
1. With screwdriver or coin, turn the power screw clockwise
until armature strikes the coil making a clacking noise.
2. Then turn the screw counterclockwise, just until the noise
stops. This is the maximum power setting.
FX810B IB-00000.indd 9-10
WARNING:
IF YOU THINK THE
POWER IS OFF WHEN
THE SWITCH IS OFF,
YOU'RE WRONG.
KEEP AWAY FROM WATER
Everyone knows that electricity and water are a dangerous
combination. But did you know that an electrical appliance
is still electrically live even if the switch is off? If the plug is
in, the power is on. So when you are not using your appli-
ances, keep them unplugged.
ALWAYS UNPLUG SMALL
APPLIANCES WHEN NOT USING.
2019/3/25 3:02 PM