Performance Data - Würth MKS 2400 Traducción Del Manual De Instrucciones De Servicio Original

Replacing the saw blade (fig. V/
fig. VI)
Switch the machine off.
■
Pull the mains plug.
■
Release the wing bolt [1].
■
Turn the small cover [2] back.
■
Lift up the vibration damper [3] and lock it
■
through lateral turning.
Press in the spindle lock [4].
■
Release the screw with the Allen key.
■
Swing the mobile saw blade protection upwards.
■
Remove the saw blade carefully.
■
Push the new blade carefully onto the axle shaft.
■
When doing so, make sure the displayed turning
direction on the saw blade is in an anti-clockwise
direction. The saw blade must rotate in the direc-
tion indicated by the arrow on the protective
cover. Make sure the saw blade is free of grease.
Put in the external flange and the screw and
■
tighten them.
Turn the small cover [2] into the basic position.
■
Tighten the wing bolt [1].
■
Set the vibration damper [3] in the basic position
■
by turning.
Release the spindle lock [4] and check whether
■
the saw blade can rotate freely.
max. Ø mm / max. a × b
b
b
Lubricating the saw blade guideways
Regularly spray the points at which the saw
■
blade comes into contact with the saw blade
guideways with lubricating oil spray.
Replacing the vibration damper
(fig. V)
If the vibration damper [3] has worn down to 1
■
mm, replace it.
Replacing carbon brushes
(fig. VII a+b)
If the carbon brushes [2] have been ground down
to approx. 6 mm, or sparks are forming, you need to
replace them. When doing so, always replace both
carbon brushes at the same time.
Pull the mains plug.
■
Remove the cover [1].
■
Remove the worn down carbon brushes.
■
Insert the new carbon brushes and close the
■
cover once more.
Keep the locking bolts [1] pulled outwards.
■
Lower the handle to the lowest position.
■
Let the locking bolts snap in.
■
3 The machine is ready for transport.

Performance data

125 mm (inox)
125 × 125 mm
b
105 × 155 mm
b
Transport (fig. X)
90°
140 mm
45°
102 mm
75 × 100 mm
75 × 100 mm
17