Assembly And Adjustments - DeWalt DE7035 Traducido De Las Instrucciones Originales

ENGLI S H
DO NOT exceed the weight this stand
can hold. The DE7035 table saw stand
is designed to support 275 kg safely in a
work environment.
DO NOT climb, sit or stand on the
stand.
DO NOT drop heavy loads on the table.
DATE CODE POSITION (FIG. 1)
The Date Code (l), which also includes the year of
manufacture, is printed into the housing.
Example:
2019 XX XX
Year of Manufacture
Package Contents
The package contains:
1 Work stand
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Beam
b. Carry handle
c. Release button
d. Leg lock lever
e. Transport latch
INTENDED USE
Your work stand has been designed to be used as a
multipurpose work surface or to extend the versatility
of your D WALT mitre saw.
e
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These work stands are professional power tools.
12
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

ASSEMBLY AND ADJUSTMENTS

WARNING: Always observe the safety
instructions and applicable regulations.
Preparation (fig. 2)
1. Place the work stand on the ground with the
folded legs facing up.
2. Depress the leg lock lever (d) or release
button (c) and pull leg up until the locking pin
clicks into place. Repeat on each leg.
3. Lift the stand by the center beam and place it in
an upright position. The stand should be stable
and should not rock.
NOTE: Ensure all locking pins are engaged and the
legs are locked in place.
Transport Latch (fig. 3)
The transport latch (e) was designed to aid in
carrying two work stands at the same time by
lashing two work stands together for transport.
1. Place one stand on the ground with the
beam (a) facing down. Place the second stand
onto the first stand with the beam facing up.
NOTE: Rotate the stands to ensure locator feet
(f) and holes (g) align to connect stands.
2. Rotate the transport latches (e) clockwise
simultaneously until they latch together. Repeat
on the other side. Ensure the two work stands
are mated properly, as shown.
3. To release the transport latch:
a. Place the stands on the ground with one
beam facing down.
b. Apply pressure to the tip of each
transport latch hook until they move in a
counterclockwise direction. Once the tips
are forced past each other the latches will
snap open.
Mounting a Sacrificial Wood Surface
(fig. 4)
The DE7035 work stand allows a 100 mm x
50 mm piece to be mounted in the top channel of
the beam (a) as a sacrificial element when needed.
This can be useful if working with a material that
could get scratched by the main beam or when
using a circular saw to cut material.