Tripp-Lite WorkWise WWSS1327RWTC El Manual Del Propietario página 4

Assembly
Attach wall rail to wall.
1
For wood stud wall installation.
WARNING
• When mounting on a wood stud wall, make sure mounting screws are anchored into the center of the studs. Use of a stud
finder is highly recommended.
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or "cinder block"), verify that the actual
concrete thickness is at least 35 mm (1-3/8") in order to hold the concrete anchors. DO NOT DRILL INTO MORTAR JOINTS!
Be sure to mount the wall mount with the included concrete anchors and anchor bolts onto solid sections of the blocks.
The solid sections can generally be found 25 mm (1") toward the middle of the block from either end. An electric drill on
a slow setting is suggested to drill the hole rather than a hammer drill so as to avoid breaking out the back of the hole
when entering a hollow section.
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
30 mm (1.2 in.)
3 mm (.12 in.)
Or For concrete wall installation.
4
F
50 mm (2.0 in.)
F
8 mm (.31 in.)