Resol Solex Manual De Instrucciones página 30

SOLEX
5.15 Energy balancing
(heat quantity meausurement)
BAlance Values/GAIN
expert/ADJ. VAlues/medium
Adj. range
Water
Propylene
Ethylene
Tyfocor LS
Factory setting: Propy
expert/Adj. Values/antifreeze
Adjustment range: 20 ... 70 %
Factory setting: 40 %
5.16 Operating notification
Options/Error rel.
Adjustment range No ... R4 + 5
Factory setting No
5.17 Error reports
Reports
5.18 Error relay
OptionS/Errorrel.
Adjustment range No ... R4 + 5
Factory setting No
| 30
With the help of the measured volume flow, the domestic
cold and hot water an energy balancing can be effected .
For an accurate heat quantity measurement it is important
to use the correct frost protection and ratio of mixture.
If the solar system is activated in order to load the store
(solar operation), the relay will be switched on. If the By-
pass option is activated, the operating notification will be
activated as soon as the Bypass circulation is heated up.
The controller itself shows following states:
- Preheating circuit active
- Solar load Std
- Solar load Stu
- Store maximum is reached
- Cooling active (Recooling / Collector cooling)
- Tube collector function active
=> Indication of the remaining standstill time
=> Indication of the remaining run time
- CS-Bypass active
=> Indication of the remaining after run time
- Antifreeze WT active
- Antifreeze Collector aktive
The relay for the operating notification can be adjusted.
You can only choose a relay that is not already being used
for a different function.
Defective temperature sensors are reported.
If there is an error at the sensors or the controller, the er-
ror relay will drop out.The realys for the error report can
be adjusted (R4 and/or R5).
This function can be used kann for an additional external
display.