Hotpoint Ariston TCD 851AX Manual De Instrucciones página 3

Important Information
Heat Pump Filter Unit...
! You MUST clean the fluff from the filter every five drying cycles to maintain the correct drying performance.
However for optimum performance and to save energy we recommend that it is cleaned before each drying
cycle.
STEP 1.
Open the Heat Pump Filter
cover
- hold the handle and
pull towards you.
STEP 4.
Separate the two parts of
the filter unit, clean any
fluff deposits from the
inside surface of the filter
mesh.
- clean the seals and
reassemble the two parts.
! Failure to clean the heat pump filter will reduce the drying performance and could cause premature failure of your
dryer. To maintain drying performance we recommend you clean this filter after every cycle.
STEP 2.
Remove the filter unit by
rotating the 4 clips to the
vertical position and then
pulling the filter towards
you.
(There may be some water
in the filter, this is normal).
STEP 5.
Refit the filter unit
- ensure that the unit is
pushed in fully, then
turn all 4 clips into the
horizontal position to
lock the cover.
! WARNING:
The front of the heat pump
is made of thin metal
plates. Take care that you
do not damage these or
cut yourself when
cleaning, removing or
replacing the filter unit.
Check that:
●
- The 4 clips are
resecured back
into their horizontal
'lock' position.
Rotate 4 clips
STEP 3.
If there is any build up of
fluff on the filter, carefully
clean this off with a damp
cloth, sponge or a vacuum
cleaner.
NEVER use your fingers.
3
GB