TUTTI bambini Versati Manual De Instrucciones página 12

• On long journeys make frequent stops. Children get tired easily. Do not remove the
child from the child car seat while travelling. If your child needs attention, find a safe
place and stop.
• Do not to use any load bearing contact points other than those described in the
instruction and marked on the child car seat. You can contact the child car seat
manufacturer if in doubt about this point.
• This approval is "Universal", which means that the child car seat can be used on all
types of vehicles.
WARNING! "Universal" means that it is compatible with most, but not all car seats.
WARNING! It is important to respect the following limitations and requirements for use
concerning the product and vehicle seat: your safety will not be guaranteed otherwise.
• This product is specifically designed to be used as a child car seat; it should not be
used indoors.
• Make sure that the buckle of the car's threepoint belt is not too high. The seat belt
buckle cannot be too long and ride too high under the armrest, preventing the car seat
from being fixed firmly. If this happens, choose another location in the car. If you have
any questions relating to this issue, you should contact the manufacturer (Fig. 1-2).
• The instructions should be retained in the child seat for its life period.
• When the child car seat is not being used to transport the child, it must not be used
for the child to sleep.
• The child must not be left on the child car seat for more than one consecutive hour.
The main tip is to make stops to remove your child from de car seat for a while, before
continuing the trip.
2. Elements of car seat
A - Headrest
B - Backrest
C - Belt Slot
D – Chest Pad
3. Applicability
• This child car seat is approved for "Group 1, 2 and 3", for the transportation of children
weighing between 9 and 36kg (from 9 up to 12 months to approximately 11 years of
age).
Mass Group I: 9kg up to 18kg
Mass Group I: 15kg up to 25kg
Mass Group III: 22kg up to 36kg
This child car seat can be used with its harness system for children of weight group I. It
must be secured with the belt fastener on the 3-point vehicle belt.
For children of weight groups II and III (15kg up to 36kg) the harness system must be
removed and the vehicle's 3-point belt system used.
12
E - Harness
F - Buckle
G - Harness adjuster lever
H - Harness adjuster strap
I - Seat cushion
J - Height adjuster
K - Head belt guide
L - Adult belt route slots
M - Harness connector