Cup Holder - TUTTI bambini Versati Manual De Instrucciones

3.1 Assemblying the product
• The seat and the backrest have adapter fitting (Fig. 3.1-1). Fit the backrest to the seat.
Make sure that it is properly seated (Fig. 3.1-2). To remove the backrest, please reverse
the operation.

3.2 Cup holder

• On the both sides of the seat, there is a guide for installing the cup holder. To install, fit
the cup holder on the guide and press down until you hear a "click" (Fig. 3-2).
4. Usage for the age group I
Use of the harness system is only permitted for children of age group I, which means
from 9kg up to 18kg (approx. 9 months to approx. 4 years).
4.1 Setting the shoulder belt height (group I)
Check whether the shoulder belts are set at the right height for your child. The
shoulders belts should be fed into the belt slots that lie at shoulder height or just above
(Fig. 4.1-1).
If the height of your shoulders belts in child car seat is not fit for your child. Adjust the
height of the shoulder belts, please proceed as follows:
Step 1: Loosen the harness (see point 4.3). Turn the child seat to the back (Fig. 4.1-2).
Step 2: Slide both of the harness o the harness connector (Fig. 4.1-3).
Step 3: Remove the buckles located on the back of the child car seat (Fig. 4.1-4).
Step 4: Now you can pull both chest pads and shoulder belts forward through the belt
slots carefully (Fig. 4.1-5).
Step 5: Now put the chest pads and harness into the corresponding belt slots (Fig.
4.1-6).
Step 6: Fit the chest pads buckles in the corresponding belt slots, and slide the harness
straps in the harness connector.
Ensure that the belt is positioned correctly in the belt slot and not twisted.
4.2 Fitting the child car seat: group I (9 up to 18kg)
Step 1: Place the child car seat on the vehicle's seat which is fitted with 3-point safety
belts ensuring it is firmly pressed against the car seat backrest (Fig. 4.2-1).
WARNING! Check that the car seat headrest does not interfere with the child car seat:
it must not push it forward (Fig. 4.2-2)
Step 2: Pull out the vehicle's belt, inserting it through the front of the adult belt route
slot (L), passing behind the backrest of the child seat and through the opposite adult
belt route slot (L), through the front of the child seat and fixing it to the vehicle buckle.
You will hear a "click" (Fig. 4.2-3, Fig. 4.2-4).
Step 3: Pass the vehicle's seat belt under the armrest on both sides. Pull the vehicle's
diagonal belt by the red indication under the armrest (Fig. 4.2-5). Make sure adult belt
has not become twisted (Fig. 4.2-6).
13