Loosening The Harness; Using The Buckle - TUTTI bambini Versati Manual De Instrucciones

Step 4: Press the child seat against the seat of the vehicle and pull the diagonal belt
along the direction as the picture shows (Fig. 4.2-7). Make sure that belt has not
loosened. Tighten the diagonal shoulder belt in the direction of the automatic roll-up as
possible (Fig. 4.2-7).
WARNING!
• Check that the child car seat is fitted firmly in place and correctly attached to the
vehicle seat; check that the seat belt is tight. If the child car seat is not tightly and safely
fitted to the car seat, repeat the installation.
• The satisfactory position of the adult seat belt relative to the child car seat is as the
Figure 4.2-7. You can contact the child car seat manufacturer if in doubt about this
point.
• To release your child seat following the above instructions in reverse order.
• Ensure that each part of the belt is tightened as possible.
• Always check that the seat belt is distributed evenly and that it is not twisted.
• NEVER fit the car seat belt in any way not illustrated in these instructions.
• Check that the cover is not impeding the movement or fit of the belt webbing in any
way.
• Make sure that the straps of seat belts are passing through the pelvic area, ensuring
that any lap strap is worn low down, so that the pelvis is firmly engaged.

4.3 Loosening the harness

• The harness is slackened by pressing the lever (under the seat cover) on the front of
the seat (G).
• Press down on the harness adjust lever (G) as you grip the two shoulder straps with
your other hand. Pull the shoulder straps towards you to loosen the harness (Fig. 4.3).
4.4 Securing the child with the harness
• Firstly, adjust the shoulder belts height (see point 4.1), proceed as follows:
• Loosen the harness (see point 4.3), open the buckle (4.4.1) and place them down
sideways.
• Fasten the buckle (4.4.1).
• Pull the shoulder straps upwards to remove the slack from the lap sections of the
harness then pull the adjuster strap (H) until the harness is fully tightened (Fig. 4.4).
• The harness should be ajusted as tightly as possible without causing discomfort to
your child.
• A loose harness can dangerous. Check the harness adjustment and tighten each time
the child is placed in the seat.
• Ensure that any lap strap is worn low down, so that the pelvis is firmly engaged, the
belt is not twisted.

4.4.1 Using the buckle

• Put the two buckle connectors together (Fig. 4.4.1-1).
14