Technical Data; Troubleshooting; Machine Data - Chicago Pneumatic SAW 14 Instrucciones De Seguridad Y Funcionamiento

Safety and operating instructions

Technical data

Troubleshooting

Problem
Saw turns too fast or develops too much
torque
Saw will not turn at all or turns too slowly
Saw does not develop enough torque
(insufficient power to cut material)

Machine data

Type
Weight without hoses and blade
Oil flow range
Max pressure relief valve setting on power
source
EHTMA category
Max back pressure in return line (measured at
saw)
Oil working temperature
Motor performance (max)
Motor torque (max)
Circumferential speed
Number of revolutions
Blade size
Arbor hole diameter
Cutting depth when used handheld
Cutting depth when mounted in cart
Required cooling capacity
18
Cause
Connected to improper power source
Power source not adjusted correctly
Power supply defect
Valve block defect
Motor defect
Power supply defect
Motor defect
SAW 14
9.8 kg (21.6 lb)
20-30 lpm (5-8 US gal/min)
170 bar (2500 psi)
C and D
30 bar (450 psi)
30-70°C (86-158°F)
6.7 kW (9.0 HP)
16 Nm (11.8 ft-lbs)
46-75 m/s (151-246 ft/s)
2500-4000 r.p.m.
355 mm (14 in.)
25.4 mm (1 in.)
133 mm (5.2 in.)
100 mm (3.9 in.)
Approx. 1.5 kW
SAW 14, 16, Cart
Solution
Use proper power source
Adjust power source flow and pressure
settings as per the manufacturer's
instructions
Disconnect saw and check power supply
Repair or replace
Disconnect power source and try to turn the
motor shaft by hand. Repair or replace
Repair or replace
Repair or replace
SAW 16
10.6 kg (23.4 lb)
20-40 lpm (5-10 US gal/min)
170 bar (2500 psi)
C, D and E
30 bar (450 psi)
30-70°C (86-158°F)
8.8 kW (12.0 HP)
21 Nm (15.5 ft-lbs)
42-85 m/s (138-279 ft/s)
2000-4000 r.p.m.
405 mm (16 in.)
25.4 mm (1 in.)
160 mm (6.3 in.)
125 mm (4.9 in.)
Approx. 2 kW
3392 5186 90a | Original instructions