Safety Instructions - General 824 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SAFETY INSTRUCTIONS

• Always turn off and un-plug power tools
before using the Digital Angle Detector
• Never use your power tools without the
correct guards in place
BUTTONS:
1. ON/OFF Power switch: Press this button
to switch on power, press and hold to
switch the power off.
2. UNIT: Once turned on the Digital Angle
Detector will display results in degrees.
Press the "Unit" button and results will
be converted into percent slope. This can
be useful when trying to find the ratio of
vertical distance to horizontal distance
that the measured angle creates. Press
the "Unit" button again and display will
return to degree outputs.
3. CALIBRATE: Absolute /Relative
measurement conversion
Press this button to set one surface as
0.00° for measuring relative angle. Press
again for 3 seconds, the unit will change
back to the state of absolute
measurement.
4. HOLD: If the measured value needs to be
saved, press HOLD to hold the display.
The arrows on both sides will blink. Press
it again to exit.
INSTRUCTIONS:
Absolute Measurement
1. Once turned ON the Digital Angle
Detector will be automatically entered
into a state of absolute angle
measurement. The display screen will
now show the angle between the
measured surface and the level
(horizontal) plane.
2

Publicidad

Tabla de contenido
loading

Tabla de contenido