Operation, Precautions - Chicago Pneumatic CP 0315 Instrucciones De Seguridad Y Funcionamiento

CP 0315

Operation, precautions

DANGER Explosion hazard
If a warm insertion tool comes into contact with
explosives, an explosion could occur. During
operation with certain materials as well as use of
certain materials in machine parts, sparks and
ignition can occur. Explosions will lead to severe
injuries or death.
Never operate the machine in any explosive
►
environment.
Never use the machine near flammable materials,
►
fumes or dust.
► Make sure that there are no undetected sources
of gas or explosives.
Never drill in an old hole.
►
WARNING Unexpected movements
The inserted tool is exposed to heavy strains when
the machine is used. The inserted tool may break
due to fatigue after a certain amount of use. If the
inserted tool breaks or gets stuck, there may be
sudden and unexpected movement that can cause
injuries. Furthermore, losing your balance or slipping
may cause injury.
Make sure that you always keep a stable position
►
with your feet as far apart as your shoulder width,
and keeping a balanced body weight.
Always inspect the equipment prior to use. Never
►
use the equipment if you suspect that it is
damaged.
► Make sure that the handles are clean and free of
grease and oil.
Keep your feet away from the inserted tool.
►
► Stand firmly and always hold on to the machine
with both hands.
Never drill in an old hole.
►
Never start the machine when it is lying on the
►
ground.
Never 'ride on the machine with one leg over the
►
handle.
Never strike or abuse the equipment.
►
Check regularly for wear on the insertion tool,
►
and check whether there are any signs of damage
or visible cracks.
Pay attention and look at what you are doing.
►
9800 0554 90b | Original instructions
Safety and operating instructions
WARNING Stalling hazard
If the insertion tool gets caught during operation,
the whole machine will start to rotate if you lose
your grip on it. This unexpected rotation of the entire
machine may cause serious injury or death.
Stand firmly and always hold onto the machine
►
with both hands.
Make sure that the handle or handles are clean
►
and free from grease and oil.
► Never drill in an old hole.
WARNING Trapping hazard
There is risk of neck ware, hair, gloves and clothes
getting dragged into or caught by a rotating
insertion tool or accessories. This may cause choking,
scalping, lacerations or death. To reduce the risk:
Never grab or touch a rotating drill steel.
►
► Avoid wearing clothing, neck ware or gloves that
may get caught.
Cover long hair with a hair net.
►
7