Extender Kit With Remote/Repeater Installation; (B140-101X And B140-1A1-Wp Extender Kits Only) - Tripp-Lite B140-101 El Manual Del Propietario

Extender Kit with Remote/Repeater Installation

(B140-101X and B140-1A1-WP extender kits only)

Notes:
1. Test to make sure the entire installation works properly before pulling cables through
ceilings/walls.
2. To achieve maximum distance and performance, use 24 AWG solid wire Cat5e/6
cable. Using stranded wire Cat5e/6 cable, or cable with a gauge (AWG) size higher
than 24 AWG will result in shorter extension distance. All Tripp Lite N202-Series
Cat6 cables are made with 24 AWG solid wire cabling.
3. The installation diagram shows a B140-1A1-WP . The B140-101X installation is the
same, except its local unit does not require power.
DVI SOURCE
1
Make sure the DVI source is powered OFF.
2
Connect the built-in DVI connector on the B140-101X local unit to the
DVI source; or, connect the DVI source to the INPUT port on the
B140-1A1-WP local unit using a Tripp Lite P561-Series DVI-D Single
Link Cable.
3
B140-1A1-WP only: Connect the external power supply to the local
unit and plug it into a Tripp Lite Surge Protector, PDU or UPS. The green
Power LED will illuminate.
17-08-508-933776.indb 11
Up to 175 ft. (50 m) at 1024 x 768 (60 Hz)
Up to 125 ft. (38 m) at 1920 x 1080 (60 Hz)
2
B140-110
B140-1A1-WP LOCAL REMOTE
TRANSMITTER REPEATER
Up to 175 ft. (50 m) at 1024 x 768 (60 Hz)
Up to 125 ft. (38 m) at 1920 x 1080 (60 Hz)
2 2
B140-110 B140-110
REMOTE REMOTE
REPEATER REPEATER
11
0
B140-1A1-WP REMOTE
RECEIVER
11/27/2017 11:47:47 AM