Extender/Splitter With Remote/Repeater Installation; (B140-1A0 And B140-1A0-Wp-1 Remote Receiver Units Only) - Tripp-Lite B140-101 El Manual Del Propietario

Extender/Splitter with Remote/Repeater Installation

(B140-1A0 and B140-1A0-WP-1 remote receiver units only)

Notes:
1. Test to make sure the entire installation works properly before pulling cables through
ceilings/walls.
2. To achieve maximum distance and performance, use 24 AWG solid wire Cat5e/6
cable. Using stranded wire Cat5e/6 cable, or cable with a gauge (AWG) size higher
than 24 AWG will result in shorter extension distance. All Tripp Lite N202-Series
Cat6 cables are made with 24 AWG solid wire cabling.
3. The installation diagram shows the B140-004. The B140-002 installation will be
the same, except there are only 2 remote ports and there is no local monitor port.
B140-004 LOCAL
TRANSMITTER
OPTIONAL LOCAL
MONITOR
DVI SOURCE
1
Make sure the DVI source is powered OFF.
2
Connect the DVI source to the INPUT port on the B140-002 or
B140-004 using a Tripp Lite P561-Series DVI-D Single Link Cable.
17-08-508-933776.indb 17
Up to 175 ft. (50 m) at 1024 x 768 (60 Hz)
Up to 125 ft. (38 m) at 1920 x 1080 (60 Hz)
2
B140-110 REMOTE/
REPEATER
2
B140-110 REMOTE/
REPEATER
2
B140-110 REMOTE/
REPEATER
2
B140-110 REMOTE/
REPEATER
Up to 175 ft. (50 m) at 1024 x 768 (60 Hz)
Up to 125 ft. (38 m) at 1920 x 1080 (60 Hz)
2 2
B140-110 REMOTE/ B140-110 REMOTE/
REPEATER REPEATER
2 2
B140-110 REMOTE/ B140-110 REMOTE/
REPEATER REPEATER
2 2
B140-110 REMOTE/ B140-110 REMOTE/
REPEATER REPEATER
2 2
B140-110 REMOTE/ B140-110 REMOTE/
REPEATER REPEATER
17
B140-1A0-WP-1
REMOTE RECEIVER
B126-1A0
REMOTE RECEIVER
B126-1A0-WP-1
REMOTE RECEIVER
B126-1A0
REMOTE RECEIVER
11/27/2017 11:47:49 AM