Sauder Entertainment Credenza Manual Del Usuario página 24

Step 19
Carefully turn your unit over onto its front edges. Unfold the BACK (H)
å
and lay it over your unit.
Make equal margins along all four edges of the BACK (H). Push on
å
opposite corners of your unit if needed to make it "square".
Fasten the top and side edges of the BACK (H) to your unit using eighteen
å
BLACK 9/16" LARGE HEAD SCREWS (XX). Use twenty-four NAILS (ZZ)
through the remaining holes in the BACK.
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHT (C).
å
NOTE: Perforations have been provided for access through the BACK.
å
Carefully cut out the holes needed.
Push the FOOT (GG) into the hole in the BOTTOM (F).
å
BLACK 9/16" LARGE HEAD SCREW
(18 used in this step)
Page 24
XX
These holes must line up
over the UPRIGHT (C).
GG
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
This perforation is
closer to this edge.
H
F
403818
ZZ
NAIL
(24 used in this step)
www.sauder.com/services