Step 22
Carefully stand your unit upright.
å
To insert the drawers into your unit, tip the front of the drawer down and drop the rollers on the drawer behind
å
the rollers on the unit. Lift the front of the drawer up and slide it into the unit.
Insert the GROMMET (II) and GROMMET CAP (JJ) into the TOP (D).
å
Push the RUBBER SLEEVES (TT) over the METAL PINS (SS). Insert the METAL PINS into the hole locations of
å
your choice in the ENDS (A and B), UPRIGHT (C), and BACKS (I and J). Set the ADJUSTABLE SHELVES (K and L)
onto the METAL PINS.
Apply the WARNING LABEL (UU) to the TOP (D). You should be able to read the label when the TV is removed
å
from the unit. When the TV is in place, it should hide the label. Peel off the backing and apply the label as shown
in the diagram.
NOTE: This is a permanent label intended to last for the life of the product. Once applied, do not try to remove it.
å
B
5 lbs.
L
J
10 lbs.
SS
(16 used)
TT
www.sauder.com/services
D
135 lbs.
K
25 lbs.
20 lbs.
N
20 lbs.
20 lbs.
JJ
II
UU
C
K
25 lbs.
20 lbs.
M
403818
WARNING
Never use this furniture with a TV that is too
large or too heavy. Severe injury or death can
occur. The TV and furniture will be unstable
and may tip.
- The TV must weigh less than 135 lbs.
- The base of the TV must be able to sit
completely on this shelf.
A
5 lbs.
L
I
10 lbs.
Page 27