EN
11.2
LUBRICATE THE BLADE
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
•
Do not oil the blade while the hedge trimmer is running.
•
Put the machine on a flat and smooth surface.
•
Use a soft cloth to clean the blades and a brush to remove
more dirt.
•
Use a light layer of oil to lubricate the blades along the
top edge of the blade.
We recommend to use the non-pollutant type oil.
12
STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
13
TROUBLESHOOTING
Problem
The motor does
not start when you
pull the trigger.
The machine
smokes during op-
eration.
The motor is on,
blades do not
move.
NOTE
NOTE
Possible cause
Solution
Make sure that
The battery pack is
you tighlty install
not installed tight-
the battery pack in
ly.
the machine.
The battery pack is
Charge the battery
out of power.
pack.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery pack.
3. Contact the
service center.
Do not use the ma-
The machine has
chine and contact
damage.
the service center.
Remove battery
The blades are
pack then clear
blocked.
blockage from the
blades.
English
Problem
There is too much
noise and/or vibra-
tion during opera-
tion.
14
TECHNICAL DATA
Voltage
No load speed
Blade length
Cutting capacity
Weight (without battery
pack)
Battery model
Charger model
15
LIMITED WARRANTY
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of four (4)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
10
Possible cause
Solution
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are
3. Inspect for
loose.
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and contact
damage.
the service center.
60V
4000 (±10%) SPM
24" (610 mm)
1.2''
11 lbs. (5 kg)
60BA02, 60BA25, 60BA03,
60BA04, 60BA05, 60BA06,
60BA08 and other BAC ser-
ies
60DP10, 606P14 and other
CAC series
GARANTIE OUTIL &
BATTERIE • GARANTÍA PARA
HERRAMIENTAS Y BATERÍAS