Grohe Freehander 27 004 Manual De Instrucciones página 5

GB
Technical Data
Minimum flow pressure
Max. operating pressure
Recommended flow pressure
Test pressure
Flow rate at 3 bar flow pressure
Normal spray jet with shower open
Pulsator spray jet with shower open
Eco spray jet with shower open
Normal spray jet, both showers open
Pulsator spray jet, both showers open
Installation
Note
• In the case of shower doors which open inwards,
install on the appropriate wall side.
• When installing e.g. on plasterboard walls (not solid
walls) it must be assured that an appropriate
reinforcement is in place to ensure sufficient
strength.
• Installation height (X) see Fig. [1] and [6] should be
adapted to the body height of the user.
Recommended installation height: (Dimensions in cm)
Body height approx. 160 165 170 175 180 185 190
Installation height (X) 155 160 165 170 175 180 185
approx.
Installation of surface-mounted Freehander 27 004
1.Mark position of fixing holes for ø8mm mounting plugs
with the aid of the supplied drilling template and then
drill, see fold-out page II Fig. [1].
When installing directly above the shower fitting, it must
be ensured that the Freehander is higher than the fitting
when folded down, see Fig. [2].
2. Install Freehander, see Fig. [3].
3. Install the attached snap coupling (B) on the supplied
shower spray hose of the shower fitting and attach to
the Freehander connection (C), see Fig. [4].
4. If an additional existing or new hand spray is used, the
supplied outlet nipple (D) must be installed onto the
hand spray, see Fig. [5]. Wall shower holder order
no. 28 605 can be ordered as an additional holder for
the hand spray.
Installation of in-wall Freehander 27 005
1. Prepare 1/2" shower connection, see Fig. [6].
2. Mark position of fixing holes for ø8mm mounting plugs
1 bar
with the aid of the supplied drilling template and then
5 bar
drill, see Fig. [7].
2 - 3 bar
For subsequent installation, as a replacement for an
existing overhead spray with a connection height of
6 bar
approx. 2050mm, the user height can be reached using
installation set order no. 27 008, see Fig. [8].
approx. 12.5 l/min
3. Install Freehander, see Fig. [9].
approx. 11.5 l/min
approx. 6.0 l/min
Operation of shower heads, see Fig. [10].
approx. 18.5 l/min
Three functions can be set by turning the adjustment
ring (G).
approx. 17.5 l/min
• Front shower (H)
• Rear shower (I)
Important:
• The bracket of the Freehander is not a safety handle
and must not be used as a handle when leaving the
bath.
• Exercise caution when touching the Freehander
following thermal disinfection as the water-bearing
pipe reaches a very high temperature.
Use of the Freehander
1. Overhead spray, see fold-out page III Fig. [11].
2. Side spray, see Fig. [12].
Maintenance
Inspect and clean all parts, replace if necessary and
grease with special fitting grease (order no. 18 012) if
required.
Turn off hot and cold water supply
I. Shower head
Disassembly, see Fig. [13].
The function of the SpeedClean nozzles is guaranteed for
a period of five years.
Simply rub SpeedClean nozzles in order to remove lime
scale from spray jet, see Fig. [14].
Replacement parts, see fold-out page I ( * = special
accessories).
Care
For directions on the care of this fitting, please refer to the
accompanying Care Instructions.
Position: MASSAGE
Position: NORMAL
Position: ECO
Position: MASSAGE
Position: NORMAL
Position: STOP= shut off
shower
2