Operating Instructions For Optional Wireless Remote - La-Z-Boy Power Plus Manual De Instrucciones

Operating Instructions for
Optional Wireless Remote
Home button
Press and release the Home button to
automatically return the furniture to its
upright, closed and stored position.
Memory I button
Press and release the Memory I button
to automatically move the furniture to the
stored setting.
(pressing and holding stores the setting)
Do Not Disturb
Slide the Do Not Disturb button to the Left (as facing)
position to turn on the feature and block out
communication between the remote and furniture.
This essentially turns off the remote commands
to safeguard against undesired movement of the
furniture. Slide it to the right (as facing) to turn off the
feature, and allow communication with the remote.
USB Output Specifications:
DANGER
– To reduce the risk of burns, electric shock,
serious injury or death:
• Liquids exposed to electricity pose an immediate risk of electric shock. Do not use this
unit if the power control is damaged, wet, in contact with or near spilled water or any
liquid. Do not use the unit if the button activation switch has been exposed to water or
any liquid. Do not handle the plug or remote control with wet hands.
46
Memory II button
Press and release the Memory II button
to automatically move the furniture to the
stored setting.
(pressing and holding stores the setting)
Find Me
Press the Find Me
button to send a signal
and locate the remote.
LED lights flash and a
loud tone plays from
the remote when the
signal is received, and
the remote equipped
with three working
AAA alkaline batteries.
USB port
Connect a USB cable
to the port to charge
a device.
5 VDC, 1.0A
Operating Instructions for
Optional Wireless Remote
Install Batteries in the Remote:
The remote requires three (3) AAA alkaline batteries (included; packed inside the electrical components bag).
1. Remove the remote and AAA batteries from the electrical components bag. Remove the plastic
wrap from the batteries.
2. Turn the remote over to access the battery compartment.
3. Slide the battery compartment cover off and set aside (F
4. Insert three AAA batteries oriented to match the polarity as in indicated by the markings in the
battery compartment (F 2 and 3).
IGURES
5. Slide the battery compartment cover back in place to close the compartment.
F 1 F
IGURE IGURE
Remove Polarity Markings Inside
Back Cover the Battery Compartment
1).
IGURE
2 F 3
IGURE
Insert (3) AAA Alkaline Batteries
47