English - Philips HP5220/11 Manual De Instrucciones

English

A clean glowing complexion proves that your skin
is healthy and well-cared-for: and thus that the
skin is cleaned carefully.
With normal skin cleansing methods, remainders
of make-up will always be left in the pores. These
methods are too superficial.
The steam from your Philips facial sauna will
open the pores, so that these residues can be
removed as well.
Important
• Read the instructions for use in
conjunction with the illustrations before
using the appliance.
• The appliance can be connected to
mains voltages in the range 220 - 240
Volts.
• Never immerse the appliance in water or
any other liquid.
• Remove the plug from the wall socket
- before cleaning the appliance;
- before filling or emptying the water
tank.
• Use the measuring beaker provided for
filling.
• Do not add oily substances to the filling
water.
• Keep the appliance out of children's
reach.
• Do not use the appliance without water.
• Avoid abrupt skin cooling down after
treatment.
• Attention: the water tank is hot after use!
• If the mains cord of this appliance is
damaged, it must only be replaced by
Philips or their service representative, as
special tools and/or parts are required.
General description
A
Facial mask
B
Water tank
C
Main unit
D
On/off switch
E
Pilot light
F
Measuring beaker with level indication
G
Mains cord
(fig. 1)
How to use
- Clean your skin as you would normally.
- Remove the plug from the wall socket.
- Place the appliance on a stable and flat surface
(e.g. table top).
- Fill the measuring beaker (F) with cold water
up to the level indication.
- Pour the water into the water reservoir (B)
(fig. 2).
- Position the facial mask (A) on to the main unit
(C).
- Insert the plug into the wall socket and switch
the appliance on using on/off switch (D). The
pilot light (E) will now come on (fig. 3).
- After about 4 minutes the appliance will begin
to produce steam.
- Protect your hair style, e.g. by covering it with a
towel.
- You can set the facial mask (A) into the
optimum position (fig. 4) by moving it forwards
or backwards.
- Use the facial sauna as indicated in fig. 5.
- You can use the facial sauna up to a maximum
of 15 minutes in any one treatment.
- Directly after use, switch the appliance off
(fig. 6) and remove the plug from the wall
socket.
- Lift the facial mask (A) from the main unit (C)
(fig. 7).
- Pour the remainder of the water out of the
water tank (fig. 8). Take care, it may still be hot.
- Clean your skin again and apply a nourishing
cream.
Although the appliance is protected against
overheating, we advise you to always switch it
off immediately after use.
Cleaning
- Remove the plug from the wall socket.
- Remove the facial mask from the main unit.
You can rinse the mask under the (hot) tap or
wash in soapy water.
- After each use, clean the main unit with a
damp cloth, if required with some liquid
detergent. Ensure that no water can enter the
appliance.
4