Publicidad
STEP 1
Remove the padded mat
inside your frame. Attach the
door support brackets using
4 of the Pan Head screws and
the two Door Mount Support
Brackets (see Figure 1). The
screws will go through the
floor of the frame to attach
the top of the Door Mount
Support Brackets to the
bottom of the frame. Do not
secure screws tightly at this
time, as they will be tightened
later in Step 7.
#2
STEP 2
Place included template into
the cabinet and secure with
tape. Use the dotted line at the
bottom to center the template
into your cabinet. Refer to
the template for orientation
directions. Use the awl and
rubber mallet to mark the holes
as shown on the template
(See Figure 2). Remove the
template and drill out holes as
previously marked.
3
32
STEP 3
Insert Toggler Anchor into
cabinet floor. To install the
Toggler Anchor, slide the
plastic snap plug down into
hole and break off excess
plastic legs. (See Figure 3)
2
2
Customer Service: 800-626-1126 | rev-a-shelf.com
FIGURE 1
PART NO. 15
FIGURE 2
FIGURE 3
STEP 3
SLIDE DOWN AND
BREAK OFF
STEP 1
PLACE THROUGH HOLE
PART NO. 17
CABINET
FLOOR
STEP 2
SECURE TOGGLE
Publicidad
