Publicidad
STEP 4
Place included Support Box
about 16" from the front of
your cabinet on the floor (See
Figure 4.1) and then extend
the frame into the open
position while resting on the
support block. Place the frame
with slides extended into your
cabinet and position over the
top of your pre-drilled holes
(See Figure 4.2).
STEP 5
Secure the frame to the
cabinet floor. Secure the
1/4-20 2" Bolts in the 2 back
corner holes first and then
secure #8x1" screws for all
other holes. (See Figure 5)
#2
STEP 6
Attach the Door Mount
Bracket Extension Pieces
and then position the door
mount bracket as shown in
Figure 6.1. Drop the door
mount bracket into the slotted
locations inside the front of
the frame and secure using
the 5mm x 12mm pan head
screws. Install the Door Mount
Bracket Caps at this time as
well. Use the rubber mallet to
secure them. (See Figure 6.2)
#2
FIGURE 4.1
PART NO. 9
FIGURE 6.1
INSERT
EXTENSION
PIECES
INSTALLATION INSTRUCTIONS: 51 SERIES MONSTER/MAJESTIC WASTE CONTAINERS
1/4-20x2" PHILLIPS
16"
FIGURE 5
PART NO. 14
SECURE FIRST
INSERT
EXTENSION
PIECES
FIGURE 4.2
BOLT LOCATIONS
#8X1" DEEP
THREAD FLAT HEAD
SCREW LOCATIONS
FIGURE 6.2
INSERT CAPS
INSERT
SCREWS
INSERT
SCREWS
PART NO. 15
3
Publicidad
