LG SXS Manual Del Propietário página 23

How to
disassemble the
automatic
icemaker
WARNING
When ice maker
does not operate
smoothly
The other
functions
22
Hold the ice maker cover with both hands and pull
it toward you while pressing the button on part (1).
- Do not disassemble the ice maker unless it is
necessary.
- Hold the ice storage bin using both hands so that it
does not fall.
- Do not touch the ice dispenser with your hand or tool.
- Because the ice maker can operate by opening the
freezer door, please take precaution.
- When you want to use the ice bucket space as the storage space, make sure
to use it by turning off the ice maker after removing the ice bucket.
Ice is lumped together
When ice is lumped together, take the ice lumps out of the ice storage bin,
break them into small pieces, and then place them into the ice storage bin
again.
When the ice maker produces too small or lumped together ice, the amount
of water supplied to the ice maker need to adjusted. Contact the service
center.
❈
If ice is not used frequently, it may lump together.
Power failure
Ice may drop into the freezer compartment. Take the ice storage bin out and
discard all the ice then dry it and place it back. After the machine is powered
again, crushed ice will be automatically selected.
The unit is newly installed
It takes about 12 hours for a newly installed refrigerator to make ice in the
freezer compartment.
Door open warning
3 times of warning sounds at the interval of 30 seconds if a minute passes
with the door of refrigerator and the hombar door opened or completely
closed.
Please contact with the local service center if warning continue to sound
even after closing the door.
Diagnosis (failure detection) function
Diagnosis function automatically detects failure when failure is found in
product during the use of refrigerator.
If failure occurs at product, it does not operate though pressing any button
and normal indication is not done. In this case, do not turn power off but
immediately contact with the local service center. A lot of time are need for
service engineer to detect the failed part if turning it off.
Operation
1
1