Replacement Parts - Zircon MetalliScanner x8 Manual Del Usuario

(Example: Ferrous)
CAL
9 . The tool will need to process over the center of the target first and when it returns to the point
with the strongest signal, the Target icon
beep intermittently when you are over the center of the target .
10 . When the center of a target has been identified, you can mark the target using the integrated
marking system by pushing down on the unit . To activate the marker when using the pivoting
handle attachment, firmly push down on the handle, holding the tool with your other hand if
needed . When using the optional pole extension, grip the pole with both hands as if holding a
paint roller and press firmly against the scanned surface .

8. rEpLaCEMENT parTS

An extra set of three glider pads (the smooth feet on the underside of the tool) and a marker stamp
are also included with your tool .
To replace the glider pads after they have worn, slide the tip of a flathead screwdriver into the
notch of the glider pad location and gently lift upwards . This should release the existing glider pad
from the base of the unit . Gently remove any existing residue . Remove the backing from the new
glider pad and securely adhere into place .
To replace the marker stamp once it is out of ink, twist the cap counter-clockwise and lift up .
Insert the new marker stamp and twist clockwise until secured into place .
To order additional sets of glider pads or marker stamps, or to purchase the accessory extension
pole, please call us toll-free at 1-800-245-9265, Monday - Friday, 8am - 5pm (PST) .
will display . If the Sound is on, the tool will also
CAL
BEEP!
EN 7