System Reset/Initial Start-Up; Troubleshooting Table - Kohler K-683 Guia Del Usuario

System Reset/Initial Start-up

After a system reset or during the initial setup, you will be prompted to set your language and shower
configuration.
Select the [Power icon] to power on the user interface.
Scroll to and select your language by pressing the [OK Icon].
Press the [Back Icon] icon to continue to the next setting.
Scroll to and select your valve configuration by pressing the [OK Icon]; you will be brought to the
"Select Name" screen.
NOTE: The select name screen lists the outlet names listed in order from outlet 1 to outlet 6. This screen
allows you to change the outlet display name only and will not change the cycling order.
If the outlet display names listed are correct for your system: Press the [Back Icon] twice to exit
the initial setup sequence.
To change the outlet display name: Scroll to and select the outlet to be renamed then scroll to and
select the new outlet display name. Refer to the "Set the Valve Configuration - Preset Options"
section for more information.
Press the [Back Icon] twice to exit the initial setup sequence.
Troubleshooting
CAUTION: Risk of personal injury. The valve may contain hot water; be careful when draining
any residual water.
IMPORTANT! Turn off the power and water supply to the valve before performing any maintenance to
the valve.
It is recommended that any valve maintenance should be performed by a Kohler Authorized Service
Representative.
This troubleshooting guide is for general aid only. For service and installation issues or concerns, call
1-800-4-KOHLER.

Troubleshooting Table

Symptoms
1. Control panel is not lit.
Kohler Co.
Probable Cause
A. Power supply is not plugged
into the outlet.
51
Press the [Ok Icon] to select your language
Recommended Action
A. Plug the power supply into the
outlet.
1043184-5-E