SOUNDMASTER highline PL530USB Manual Del Usuario página 13

1. Plug the AC POWER CORD into a 230V AC ~ 50Hz outlet.
2. Turn the System on by sliding the Function Selector (11) to either "TUNER", "USB/SD" or
"PHONO". The LCD backlight will turn on.
Mains plug should be regularly checked for any damage. If it is damaged do not operate the unit, seek
advice from a qualified service technician. Do not attempt to operate the unit on any other power
source as this could cause damage to the unit and void your warranty.
Remarks:
If there is a malfunction due to electrostatic discharge (ESD), reset the unit by unplugging the AC
CORD from the outlet, wait 30 seconds and then plug the AC CORD in again to reset to normal
operation.
1. Slide the FUNCTION Selector (11) to the "TUNER" position.
2. Slide the BAND Selector (12) to either AM, FM or FM ST (FM Stereo Mode).
3. Rotate the TUNING CONTROL (13) until you reach the radio station you wish to listen to. The
radio station frequency shows on the LCD DISPLAY.
4. Adjust the sound level by rotating the VOLUME CONTROL (21).
5. To turn off the radio, Slide the FUNCTION Selector (11) to the "OFF" position. The LCD DISPLAY
will go "off".
FM stereo RECEPTION
1. With the BAND Selector (12) in the "FM ST" position, the FM Stereo Indicator "
when listening to a strong station that is broadcasting in "Stereo".
2. Slide the BAND Selector (12) to the FM position if the FM stereo reception is weak. The reception
may improve, but the sound is now monaural (MONO).
TIPS FOR BEST RECEPTION
AM – The AM antenna is located inside the cabinet of the main unit. If AM reception is weak,
change the position of cabinet until the internal antenna picks up the strongest AM signal.
FM – During FM reception, always keep the FM Wire Antenna fully extended. If FM reception is
weak try repositioning the FM Wire Antenna until you find the strongest FM signal
1. Raise the Turntable Dust Cover.
2. Remove the stylus protector and release the Tone Arm Clamp (6).
3. Slide the Function Selector (11) to "PHONO".
4. Place a record on the turntable, over the center spindle.
5. Set the Speed Selector Switch to 33, 45 or 78 rpm according to
the record you are playing. Place the included 45 RPM adaptor (2)
over the center spindle when playing 45 rpm records.
6. Move the Tone Arm to the beginning of the record or to the beginning of a particular track. Gently
lower the Tone Arm onto the record to start playing. Adjust the Volume if needed. The Turntable
will stop automatically when the record finishes.
7. To stop the record before it ends, lift the Tone Arm (4) using the Cue-lever (3) and return it
carefully onto the Tone Arm Clamp (6).
8. Replace the stylus protector on the stylus when not in use.
NOTE:
i. Do not stop or turn the platter manually.
ii. Moving or jarring the turntable without securing the Tone arm clamp could result in
damage to the Tone arm.
ENGLISH
AC OPERATION
RADIO OPERATION
PLAYING PHONO RECORDS
ENG 2
" will light up