SOUNDMASTER highline PL530USB Manual Del Usuario página 14

AUTO-STOP SWITCH OPERATION
The Auto-Stop area on some records may extend beyond the preset setting. As a result the turntable
could possibly stop before the last track finishes. If you experience this during playback, set the
AUTO-STOP Switch (27) located on the back of the unit to the "OFF" position. The turntable will now
run to the end of the record, but will no longer stop automatically. To stop the turntable you will need to
either set the Function Selector (11) to the OFF position or return the AUTO-STOP Switch (27) to the
"ON" position. After the record stops, lift and return the Tone Arm (4) carefully back onto the Tone Arm
Clamp (6).
IMPORTANT:
Moving or jarring the Turntable without securing the Tone Arm Clamp (6) could result in damage to the
Tone Arm (3).
This System accepts stereo headphones with a 3.5mm plug and an impedance of 8 ohms or greater.
Inserting the plug of your headphones into the Headphone jack (22) will enable you to listen privately.
When using headphones, the speakers will be disconnected automatically.
READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES
1. Avoid extended play at very high volume as it may impair your hearing.
2. If you experience ringing in your ears, reduce the volume or shut off your unit.
3. Keep the volume at a reasonable level even if your headset is an open-air type designed to allow
you to hear outside sounds. Please note that excessively high volume may still block outside
sounds.
NOTE:
We recommend that you reduce the volume control to a lower level before putting on the headphones.
After putting on the headphones, gradually increase the volume to a comfortable listening level.
You can convert you favorite records into MP3 files and store then on a USB Flash Drive or
SD/MMC Memory Card via the USB port (23) or SD/MMC slot (24) located on the front panel.
1. Insert a USB flash drive into the USB PORT (23) or an SD/MMC Memory Card into the
SD/MMC Slot (24) located on the front panel.
2. Press the RECORD Button (18), "REC" and "USB" will begin to flash in the display, If a USB
Flash Drive is inserted. If an SD/MMC Card is inserted then "REC" and "CARD" will flash in
the display. If both USB and SD/MMC card are inserted, then Icon "SEL" will also appear and
flash in the Display.
3. You can use the SKIP + Button (14) or the SKIP - Button (15) to select what media you want
to record to.
4. Select the track to be encoded and start playing the record.
5. Press the Record button to start sync encoding. The following will be displayed depending
on what media you are using to store the music.
Encoding to USB
6. To stop encoding press the STOP/USB/SD Button (19).
ENGLISH
USING HEADPHONES (NOT INCLUDED)
ENCODING RECORDS(PHONO) TO MP3
ENG 3
Encoding to Card