Greentouch DF1904-289 Instrucciones De Ensamblaje, Cuidado Y Uso página 6

OPERATING INSTRUCTIONS
Control Panel
Controls and Display
The control panel will display the heater setting when the unit power is turned ON. Whichever control icon you
press will flash the current setting of the corresponding function. Press the control icon again to adjust the
setting. Following adjustment of any setting(s), the unit will resume to display the thermostat setting after 3
seconds.
Power function
• When the unit is plugged-in but not in use, "—"will illuminate to indicate that it is in stand-by mode.
• Press the POWER ICON to turn the main power to the unit ON or OFF.
• When the unit is powered ON, the control panel will display the thermostat setting to indicate the
unit has power.
• Functions stored in memory will resume at the last setting.
• When the unit is powered OFF, the fan will continue to blow for a 45 second cool-down cycle prior
to shutting down (a countdown will be displayed).
Thermostat function
• This heater has a thermostat sensor to control the ambient temperature of the surrounding area.
• Press the INCREASE and DECREASE icons to set the temperature (long-hold to scroll quickly).
The thermostat setting range is 60°F (15.5°C) to 85ºF (29.4°C).
Note: This may not exactly match the room thermostat reading as their sensors are located in
different areas.
• Set the thermostat to ON to have the heater run continuously.
Heat settings
• Press the HEATER ICON to flash the current heater setting.
• Press the HEATER ICON again to scroll through the heater settings.
H2: HIGH Heat
The heater will cycle at 1500W power when the ambient temperature is equal or below the
Thermostat setting. Set the Thermostat to ON to have the heater run continuously at 1500W.
H1: LOW Heat
The heater will cycle at 750W power when the ambient temperature is equal or below the Thermostat
setting. Set the Thermostat to ON to have the heater run continuously at 750W.
: ECO Mode
The heater will cycle with optimal efficiency between 1500W and 750W to maintain the Thermostat
setting.
Remote Control
6
To use the remote control, first
remove the plastic tab by gently
pullling it out of remote control.