Intended Use; Functional Description - Black+Decker CS1216 Manual De Instrucciones

B175.1-1991 (when tested on
a representative sample of chainsaws.)
• normal cutting Position - Those
positions assumed in
performing the bucking and felling cuts.
• notching undercut - A notch cut in a
tree that directs the tree's fall.
• rear Handle - The support handle
located at or toward the rear of the saw.
• reduced kickback Guide Bar - A guide
bar which has been demonstrated to
reduce kickback significantly.
• replacement Saw chain - A chain that
complies with kickback performance
requirements of ANSI B175.1-2000 when
tested with specific chainsaws. It may not
meet the ANSI performance
requirements when used with other saws.
• Saw chain - A loop of chain having
cutting teeth, that cut the wood,and that is
driven by the motor and is supported by
the guide bar.
• ribbed Bumper - The ribs used when
felling or bucking to pivot the saw and
maintain position while sawing.
• Switch - A device that when operated will
complete or interrupt an electrical power
circuit to the motor of the chainsaw.
• Switch linkage - The mechanism that
transmits motion from a trigger to the
switch.
• Switch lockout - A movable stop that
prevents the unintentional operation of
the switch until manually actuated.

InTenDeD uSe

Your BLACK+DECKER Chainsaw is ideal
for pruning applications and cutting small
logs up to 16 inches (406 mm) in diameter.
This tool is intended for consumer use only.
Save THeSe InSTrucTIonS

functional deScription

12
1. Trigger switch
2. Lock-off button (not shown)
3. Front hand guard
4. Guide bar
5. Saw chain
6. Sprocket cover
7. Bar adjust locking knob
8. Chain tensioning wheel
2
14
10
1
13
15
8
SyMBolS
The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V .................volts
A .................amperes
Hz ...............hertz
W ................watts
min .............minutes
or AC .....alternating current
or DC ...direct current
n o ...............no load speed
................Class I Construction
................earthing terminal
...............safety alert symbol
...............Class II Construction
.../min or rpm...revolutions or
m/s .............meters per second
in ................inches
mm .............millimeters
...............Read instruction manual
................Use proper respiratory
...............Use proper eye protection
................Use proper hearing
PreParInG your
cHaInSaw for uSe
warnInG:
all instructions. Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious personal
injury.
11
3
6
7
9. Guide bar scabbard
10. Rear handle
11. Front handle
12. Power cord
13. Extention cord retainer
14. Oil cap
15. Oil level indicator
6
(grounded)
(double insulated)
reciprocation per minute
before use
protection
protection
read and understand
4
9
5