Troubleshooting For Anynet - Samsung 620 Serie Manual Del Usuario

Troubleshooting for Anynet +

Symptom
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The message Connecting to
Anynet + device... appears on the
screen.
The Anynet + device does not play. You cannot use the play function when Plug & Play is in progress.
The connected device is not
displayed.
The TV program cannot be
recorded.
The TV sound is not output
through the receiver.
BN68-01800A-01Eng.indb 108
Solution
Check if the device is an Anynet + device. The Anynet + system supports Anynet +
•
devices only.
• Connect only one receiver (home theater).
Check if the Anynet + device power cord is properly connected.
•
Check the Anynet + device's Video/Audio/HDMI 1.3 cable connections.
•
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
•
• Check whether the TV remote control is in TV mode.
Check whether it is Anynet + exclusive remote control.
•
Anynet + doesn't work in certain situations. (Searching channels, Operating
•
WISELINK, Plug & Play, etc.)
• When connecting or removing the HDMI 1.3 cable, please make sure to search
devices again or turn your TV off and on again.
Check if the Anynet + Function of Anynet + device is set on.
•
Check if the Anynet + device is properly connected to the TV and check if the
•
Anynet + (HDMI-CEC) is set to On in the Anynet + Setup menu.
• Press the TV button on the TV remote control to switch to TV. Then press the
TOOLS button to show the Anynet + menu and select a menu you want.
Select View TV in the Anynet + menu.
•
• Press the SOURCE button on the TV remote control and select a device other
than Anynet + devices.
• Press CH, CH LIST, PRE-CH, and FAV.CH to change the TV mode.
(Note that the channel button operates only when a tuner-embedded Anynet +
device is not connected.)
You cannot use the remote control when you are configuring Anynet + or
•
switching to a view mode.
Use the remote control when the Anynet + setting or switching to view mode is
•
complete.
Check whether or not the device supports Anynet + functions.
•
• Check whether or not the HDMI 1.3 cable is properly connected.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
•
Search Anynet + devices again.
•
You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI
•
cables may not support Anynet + functions.
• If it is terminated by an abnormal situation such as disconnecting the HDMI cable
or power cord or a power failure, please repeat the device scan.
Check whether the antenna jack on the recording device is properly connected.
Connect the optical cable between TV and the receiver.
English - 108
2008-10-24 10:44:42