Textron Greenlee TG-2000 Manual De Instrucciones página 10

Operation
LASER RADIATION–DO NOT
STARE INTO BEAM
Max. Output <1 mW,
Wavelength: 635-660 nm
Complies with 21 CFR, Chapter 1, subchapter J
1. Refer to "Typical Measurements" for specific measuring instructions.
2. Test the unit on an object with a known temperature.
• If the unit does not function as expected on an object of known temperature, replace the
batteries.
• If the unit still does not function as expected, call Greenlee for technical assistance
at 800-435-0786.
3. To measure the temperature of a selected area: Press and hold the trigger and point the ther-
mometer at the object to be measured. The dual lasers indicate the approximate diameter of the
measured area. "SCAN," the measured temperature, and advanced feature data will appear on the
display. The scan icon will blink. Release the trigger after completing the measurement. "HOLD,"
the final temperature measurement, and advanced feature data will remain on the display for
1 minute.
4. To take more than one temperature measurement, or to locate a hot spot: Press and hold the
trigger, and scan the objects to be measured. The unit will record the maximum, minimum, differ-
ence, and average temperatures.
To perform other functions, refer to "Advanced Features" in the "Using the Features" section.
Limitations
• The thermometer cannot measure through transparent objects, such as glass or plastic. It will
measure the surface temperature of the glass or plastic.
• Steam, dust, smoke, or other particles can prevent accurate measurement by obstructing the unit's
infrared sensor.
Locating a Hot Spot
To find a hot spot, aim the thermometer outside the area of interest, and then scan across with an up
and down motion.
10
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
CLASS II LASER PRODUCT
CAUTION–CLASS 2
LASER RADIATION WHEN OPEN