Utilitech 7115-01 Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
3.
Remove wiring box cover (3.1) from fan housing
(A). Remove wiring knockout (3.2) from wiring box
cover with flathead screwdriver (not included).
4.
Install a circular 4 in. duct (4.1) (not included) and
secure it with duct tape or clamps (neither included).
5.
Pull the house wires through the wire box cover
hole. Using a quick connector, secure 120 V AC
house wiring from the wall switch to the fan as
shown in the wiring diagram on page 5. 14 AWG
is the smallest conductor that should be used for
branch-circuit wiring.
Carefully push the connected wires back into the
wiring box housing. Reattach the wiring box cover.
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house
wire represents before connecting. You may need to
consult an electrical contractor to determine safely.
3
A
2.1
3.1
4
4.1
5
9
3.2
2.2
4 in. Duct
Duct tape
or clamp
Ceiling

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

0831387

Tabla de contenido