Schrack BZ327900 Instrucciones De Empleo página 13

4. Transferring the time
4.1 From the PC to the taxxi
The time is transferred to the taxxi from the PC via the serial interface.
4.2 From the taxxi to the time switch
The time is transferred via the infrared interface from the taxxi to the relevant time
switch or is read out by the taxxi from the time switch.
Select "c lo" with the Prog. key.
Hold the taxxi directly on the two IR diodes (hold the taxxi still during this operation)
Press the corresponding key twice, depending on the transfer direction –
in or out
• Press the key once. The transfer is prepared.
c lo and the assignment in or out flash alternately.
• Press the key again. The time is transferred. An audible signal
is output during transfer.
If the time has been correctly transferred, c lo can be seen in the display.
If the time has not been correctly transferred, there is a short audible signal and the
corresponding error message Er x appears in the display (see Section 5).
GB
1