Install The Camera - Axis T99A Guia De Instalacion

AXIS T99A Positioning Unit
3. Replace the front cover and tighten the four front cover screws (torque 3.0 Nm).
4. Apply power to the product.

Install the camera

NO TICE TICE
NO NO TICE
The camera shown here is exemplary only, and may differ from the one you are using
with this Axis product.
1
Camera housing top cover
2
Heater holder screw (T20, x2)
3
Heater holder with heater
4
Camera housing bottom cover
5
Camera housing cover screws (T20, x4)
1. Unscrew the four camera housing cover screws (T20) and detach the top cover from
the bottom cover.
2. Unscrew the two heater holder screws (T20) and remove it from the bottom cover.
24