Layout And Items Supplied - EINHELL TC-CS 1410/1 Manual De Instrucciones Original

gaged in the workpiece. The bottom safety
hood must operate automatically for all other
sawing work.
d) Do not place the saw on a workbench
or on the floor unless the bottom guard
hood is covering the blade. An unprotec-
ted, moving saw blade will cause the saw to
move opposite to the sawing direction and
saw through anything in its way. Remember
that the saw takes a little time to slow down
and stop.
Additional safety instructions for all saws
with splitter
a) Choose the appropriate splitter for the
saw blade used. The splitter must be thicker
than the basic blade thickness of the saw bla-
de, but thinner than the width of its teeth.
b) Adjust the splitter as described in this
operating manual. Incorrect strength, po-
sition and alignment could lead to inefficient
recoil prevention.
c) Always use the splitter except for plunge
cuts. Re-attach the splitter after the plunge
cut. The splitter is disruptive when making
plunge cuts, and can lead to a recoil.
d) In order for the splitter to function, it must
be situated in the sawing gap. For shorter
cuts the splitter is ineffective for recoil preven-
tion.
e) Do not operate the saw if the splitter is
bent. Even a very small fault can cause the
guard hood to close more slowly.
•
Wear a protective dust mask!
•
Make sure that the splitter is adjusted so that
its distance to the saw blade gear rim does
not exceed 5 mm and the gear rim does not
project over the bottom of the splitter by more
than 5 mm.
•
When you want to cut wood or similar mate-
rials, use only saw blades which are recom-
mended by the manufacturer and comply with
EN 847-1.
Do not lose these safety instructions
Anl_SA_TC_CS_1410_1_SPK8.indb 21 Anl_SA_TC_CS_1410_1_SPK8.indb 21
GB

2. Layout and items supplied

2.1 Layout (Fig. 1a/1b)
1. Handle
2. ON/OFF switch
3. Locking button for ON/OFF switch
4. Locking lever for cutting depth setting
5. Power cable
6. Soleplate
7. Locking lever for miter setting
8. Locking screw for parallel stop
9. Scale for miter angle
10. Additional handle
11. Guard hood
12. Saw blade 184 x 16 mm
13. Saw blade wrench
14. Connection for sawdust extractor
15. Lever for opening the swing guard hood
16. Parallel stop
17. Screw for securing the saw blade
18. Flange
19. Swing guard hood
20. Splitter
21. Spindle Lock
22. 16 mm blade holder
2.2 Items supplied
Please check that the article is complete as
specified in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suffocating!
- 21 -
11.03.2021 10:31:22 11.03.2021 10:31:22