Connecting The Dmx Connection Cable; Connect The Units To The Power Supply Distributor; Start-Up - Oase FM-Master Manual De Instrucciones

- EN -
5.4

Connecting the DMX connection cable

How to proceed:
 G
1. Remove the protection cap from the unit.
2. Fit the connector of the connection cable and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
5.5

Connect the units to the power supply distributor

• Do not connect any InScenio controllers or portable multiple sockets to the unit.
How to proceed:
1. Choose a suitable socket (see fig. above) and insert the unit power plug into the socket.
– Check that your OASE unit may be connected to this socket. For this purpose, consult the instructions of
use of the unit you wish to connect.
– The following applies: Units powered via a transformer may not be connected to a socket with dimmer
function.
 H
2. Fit the protection hood.
6

Start-up

The unit is operated via the "Oase FM-Master" app on your smartphone or tablet. For this your
smartphone/tablet has to be connected to the FM-Master WLAN via WLAN.
The range of the WLAN connection between the FM-Master and your smartphone/tablet can span a distance
of up to 80 m provided there are no obstructions and there is no source of interference.
• The network name (SSID)  and standard password  are speci-
fied on the adhesive label next to the unit type plate on the FM-
Master WLAN.
• The connection is encoded and protected by a password.
– Recommendation: Change the password when starting the unit
up for the first time to prevent access to the FM-Master WLAN
by unauthorised persons.
• The last six characters of the network name (SSID) "Oase FM-Master <xxxxxx>" are specific to the unit
and are preset.
• The FM-Master WLAN has the password "oase1234" in its factory default setting. You should change the
password when starting up for the first time for reasons of security.
Proceed as follows when starting up the unit for the first time:
• Install the app.
• Connect the FM-Master WLAN to the power supply.
• Establish the WLAN connection.
26
1 Socket 1, switchable (max. 10 A / 2000 W)
2 Socket 2, switchable (max. 10 A / 2000 W)
3 Socket 3, switchable (max. 10 A / 2000 W)
4 Socket 4, switchable and dimmable (40 W ... 320 W)
Note: Ensure that the total output of 16 A / 3600 W is not exceeded!