Timberpro M2600-3 Manual Del Propietário página 12

5. Set up
WARNING
Pay attention to the correct direction of the saw
chain.
3. Fit the chain tensioner nut into the lower hole of the
guide bar, then install the chain cover, and fasten the
mounting nut to finger tightness.
(1) Hole
(2) Moving direction
(3) Chain tensioner nut
4. Adjust the chain tension by turning the tensioner screw
until the tie straps just touch the bottom side of the
bar rail.
(1) Chain tension adjusting screw
(a) Loosen (b) Tighten
5. Tighten the mounting nut securely with the bar tip held
up (TORQUE: 8.9 ~ 11.7 N.m./90 ~ 120 kg-cm). Then
check the chain for smooth rotation and correct ten-
sion while moving it by hand. If necessary, readjust.
(1) Tighten
WARNING
It is very important to maintain the proper chain
tension. Rapid wear of the guide bar or the chain
coming off easily can be caused by improper ten-
sion. Especially when using a new chain, take good
care of it since it should expand when first used.
BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Depending on the working posture, slide clamp up or
down until unit balances and the strap fits your body.
GB 10