Configuration / Initial Installation - Carbest 49899 Manual De Usuario

ENGLISH

CONFIGURATION / INITIAL INSTALLATION

Switch on:
Make sure that the On / Off switch on the bottom / back of the TV is set to I.
Press the Power button on the LED TV or on the remote control.
The standby indicator lights up green.
Standby:
Press the Power button on the LED TV or on the remote control. The standby indicator lights up red.
Switch off:
Press the On / Off switch on the bottom / back of the TV set.
Initial installation / automatic channel scanning:
1. Press the Power button (On / Off) on the LED TV or on the remote control to start operating
the TV set.
2. Press the p/q buttons to select Language, Country, Home condition and Automatic shut-off.
3. Press t/u to change the menu settings.
Press "OK" to confirm the input; the following menu will appear:
Make sure that your antenna, your cable system or your satellite dish is connect to the TV.
You can change the settings with the p/q/t/u buttons.
Press "OK" again to start scanning.
The TV now begins to install the service you have selected.
Depending on the service, this can take a while.
56