Power Supply Unit Section; Section For The Connections, Control And Monitoring Of The Battery - dB Technologies B-HYPE m Manual De Uso

POWER SUPPLY UNIT SECTION

This section contains:
• connector for the supplied power supply cable
• three-state switch:
ON - full operation of all functions
and operation both with network cable and
with battery only in mobile mode.
OFF - no operation (device completely off)
RECHARGE - the system in stand-by,
connected to the network, recharges the
inner battery and the BT-BHM radio
microphone, if any.

SECTION FOR THE CONNECTIONS, CONTROL AND MONITORING OF THE BATTERY

This section contains inputs/outputs and volume
mixer adjustments. All monitoring LEDs of the
system and of the internal battery are also present.
In particular, the following can be found:
• CH1: Combo connector (XLR/TRS) with relevant
input type switch and volume rotary switch. If
a microphone is connected, select the position
Mic.
• CH2: The connectors available are AUX (3.5 mm
mini-jack) and RCA stereo with relevant volume
rotary switch of the channel.
• MASTER SECTION (3 rotary switches): general
volume switch, TREBLE and BASS equalization
rotary switches.
• VOLUME ROTARY SWITCH
it controls the volume of the playable media
(see section "MEDIA PLAYER INTERFACE" for
further information)
• Line Output: unbalanced connector to link
the B-HYPE MOBILE output to another active
loudspeaker (e.g. another B-HYPE MOBILE
system). For example, the Line Output of a
B-HYPE MOBILE can be connected to the CH1 of
a second one to obtain a distributed system.
• CH1/RF Priority. In "On" position the audio
level of the 2 channels CH2 and
SD is immediately reduced by the presence
of a signal on CH1 or on the radio frequency
microphone.
B-HYPE MOBILE
26
The monitoring LEDs of the system and of the
internal battery provide immediate information to
the user.
The POWER LED indicates whether B-HYPE MOBILE
/USB/SD:
is on (green light) or off.
The internal battery will recharge with B-HYPE
MOBILE connected to the power mains (through
the cable supplied) and in RECHARGE position. The
recharge is carried out in a less efficient manner
also during the operation in ON position.
The CHARGE LED is red if the battery is flat, and
green when completely charged.
When B-HYPE MOBILE is used in mobile mode
/USB/
(without power supply cable), in ON, the Battery
level LEDs turn on depending on the battery charge
status.
English
Code 420120272 REV. 1.1