Change Of Frequency Band - dB Technologies B-HYPE m Manual De Uso

In particular cases and when necessary, it is possible to
reconfigure the transmitter-receiver frequency band.
To do this you need to purchase a new transmitter and a
new receiver, both operating in the new band.
The 3 bands shown in the previous page could not be
all available, depending on the Country of sale (refer to
your authorised dealer).
!
WARNING
The operation must be carried out with
product turned off and disconnected
from the power mains. It must be
carried out by qualified personnel
in order to prevent any electrostatic
discharge (ESD) that could damage the
product.
The procedure requires to replace the receiver
installed on B-HYPE MOBILE and then proceed with
the synchronisation with a new radio microphone that
works in the new selected band.
To replace the R-BHM receiver:
• With device off, disconnect any audio and power
supply wiring.
• Loosen the 2 screws of R-BHM
• Partially remove the receiver and disconnect the
three mini-connectors shown:
C1 - 3-pin connector (power supply-audio)
C2 - 2-pin connector (antenna A)
C3 - 2-pin connector (antenna B)
• Bring the new R-BHM operating in the new band
closer
• Connect C1, C2, C3
• Completely insert R-BHM
• Tighten the 2 screws of R-BHM
For full functionality, synchronise the transmitter/
receiver as shown in the relevant paragraph.
B-HYPE MOBILE
34

CHANGE OF FREQUENCY BAND

English
Code 420120272 REV. 1.1