Operation Methods; Water Drainage - COLUMBIA VAC KLC9000 Manual De Instrucciones

OPERATION METHODS

Cooling mode
Default Cool mode after operating the machine or press Mode button to choose Cool
mode, the Cool mode indicator will flash.
· Press UP or DOWN button to set room
temperature between 17 to 30.
· Press FAN SPEED button (or High/Low button) to select high, low fan speed.
Fan mode
· Press Fan button to choose Fan mode, the Fan mode indicator will flash.
· Select the fan speed by press SPEED button or press High / Low button directly.
· The temperature can not be set.
Automatic adjusting mode
· Press Mode button to choose the automatic mode. Automatic mode indicator will flash.
After choosing the automatic mode the running state will depend on room temperature.
When room temperature is higher than 25, it will come into cool mode. On the contrary,
it will be fan mode.
Sleep Mode (Optional Function)
Press this button to activate or cancel sleep function in cooling mode
The unit will run at the low fan speed as default with lower noise. The setting temperature
will increase 1 degree per 2 hours running time, and it will not change after increasing 2
degrees
Max cool Mode (Optional Function)
Press this button to activate the Max cool mode.
The unit runs cool but is not restricted by the temperature under the Max cool mode
The unit is forced to be in high fan speed under the Max cool mode and the fan speed
cant be set
Timer mode
. When the appliance is switch off, press Timer button to set timer-on.
· Press Up or Down button to adjust time from 0 to 24 hours. The Timer on indicator will
flash.
When the appliance is running, press Timer button to set timer-off.
Press Up or Down button to adjust time from 0 to 24 hours. The Time off indicatorwill
flash.

WATER DRAINAGE

This product has a self-evaporative system. The condensing water will be recycled to cool
the condenser. This can not only improve cooling efficiency, but also save energy for you.
· If the inside water is full, the display panel will display "FL", and the compressor will stop
running.
16|EN