Install The Hood; Lamp Replacement - Kenmore 233.5580 Serie Manual De Uso Y Cuidado E Instalación

1. Hang hood from (4) Mounting Screws (from parts
bag). Slide hood towards wall until mounting screws
are engaged in narrow end of (4) Keyholes. Tighten
mounting screws securely.
CAUTION: Do not push on fan blade! Pushing
!
on the blade may cause it to interfere with
other hood parts.
2. Connect ductwork to hood. Use Duct Tape to make
joints secure and air tight.
1. Pull Tab on Light Lens forward and pull down to
remove lens.
See page 4 for Bulb information.
Bulbs available by calling Sears at
1-800-4-MY-HOME
!
CAUTION: Bulbs may be hot! Refer to bulb
packaging for further information.
2. Grasp Lamp at base, tilt down and pull out to
remove. Replace with 42W Fluorescent Lamp
GX24Q-4. Night Light uses 4W, C-7 bulb.
3. Replace light lens.

INSTALL THE HOOD

LAMP REPLACEMENT

®
10
KEYHOLE
(4)
MOUNTING
SCREW
(4)
DUCT
TAPE
LIGHT
LENS
4W
NIGHT LIGHT
C-7 BULB
42W
FLUORESCENT
LAMP GX24Q-4