Kenmore 233.5580 Serie Manual De Uso Y Cuidado E Instalación página 8

5. Remove either top or back wiring knockout and
install approved Electrical Cable Clamp.
6. Remove appropriate Duct Knockout(s) from top
or back of hood.
7. 3¼" x 10" Ducted Discharge Only:
Attach Damper/Duct Connector over knockout
opening. Make sure damper Pivot is nearest to
Top/Back Edge of hood. Remove Tape from
damper flap.
8. 7" Round Ducted Discharge Only:
Re-install 7" Round Duct Plate removed in Step
#1 under "PREPARE THE HOOD" section. Install a
7" round damper (purchase separately). Damper
flap must open freely in direction of air flow (away
from range hood).
NOTE
To accomodate off-center ductwork, the Damper/
Duct Connector can be installed up to 1-inch on
either side of hood center or the 7" Round Duct
Plate can be installed up to ½" on either side of
hood center. In extreme off-center installations,
one end of the duct connector may need to be
trimmed to clear the electrical cable clamp.
TOP RECTANGULAR
DUCT KNOCKOUT
(REMOVE FOR 3¼" X 10"
VERTICAL & FOR 7"
ROUND DISCHARGE)
REAR
RECTANGULAR
DUCT KNOCKOUT
(REMOVE FOR 3¼" X 10"
HORIZONTAL DISCHARGE)
UP TO 1"
SIDE-TO-SIDE
ADJUSTMENT
PIVOT
8
ELECTRICAL
CABLE
CLAMP
SEMI-CIRCULAR
DUCT KNOCKOUT
(REMOVE FOR 7"
ROUND DIS-
CHARGE)
TOP/BACK
EDGE
TAPE
DAMPER/DUCT
CONNECTOR
(VERTICAL
DISCHARGE
POSITION SHOWN)