afx light PROPAR6-HEX Manual De Instrucciones página 7

You can use this mode to send the local unit's self-edited programs to the slaves.
Select UPLOAD, press ENTER. "PASSWORD" will be displayed. Press ENTER again, input the password
UP+DOWN+UP+DOWN, press ENTER, "SEND..." will be displayed; this means the data of the master unit's self-edited
programs is sending. At the same time, the master unit lights yellow. At the end of the transmission "END" will display,
and the master lights green; If Slaves received the data correctly, they light green too, if incorrect, they light red.
RESET
You can use this mode to recover the default setting of the unit.
Select RESET and press ENTER. "PASSWORD" will be displayed. Press ENTER again, input the password
UP+DOWN+UP+DOWN, press ENTER. "RESET..." will be displayed. This means the default setting is recovering. "END"
will be displayed when finished.
DIMMER
Select DIMMER, press ENTER, then use UP and DOWN buttons to select the following dimmer modes:
OFF (Close dimmer curves, instant dimmer response)
DIM 1 (Linear dimmer, Fast)
DIM 2 (Non-linear dimmer, Slow)
DIM 3 (Non-linear dimmer, Slower)
DIM 4 (Non-linear dimmer, Slowest)
RGB TO W
In this mode, the user chooses if the customized setting of the white balance (main menu 9. CALIB) applies or not.
Select RGB TO W, press ENTER, use UP and DOWN buttons to select ON or OFF
"ON" means that the white balance setting is available, OFF means it is not available.
When "RGB TO W" is set to ON, the STATIC / COLOR and DMX colors mixing will use these colors value ranges.
SlaveNum
You can use this mode to set a special asynchronous slaves chain.
When set Slave Number to Slave 00, the slave will work like the master in ordinary slave mode.
When set Slave Number to Slave 01 ~ Slave 15, the slave units will work with an asynchronous effect. The maximum
asynchronous slave number is 15.
7. KLOCK (Keys lock/unlock password)
Press MENU to select KLOCK, press ENTER. Then use UP and DOWN buttons to set the keys lock function to ON or OFF.
When select ON, the keys will be locked after 30 seconds without operating.
Input password UP+DOWN+UP+DOWN, press ENTER to unlock the keys.
When select OFF, the key lock function is not available.
8. EDIT (Self-edit Scene Programs)
You can use this mode to edit some scene programs without DMX controller.
A total of 10 programs can be set, each program can contain up to 30 scenes, each scene has 9 parameters.
Press MENU to select EDIT and press ENTER.
Use UP and DOWN buttons to select CUSTOM01 ~ CUSTOM10, press ENTER. Use UP and DOWN buttons to select
Scene SC 01 ~ SC 30, press ENTER again, then edit the following values of parameter:
RED/GREEN/BLUE/WHITE/AMBER/PURPLE values: 0~ 255
STROBE values: 0~ 20
©Copyright LOTRONIC 2017 PROPAR-HEX 7